Nineteen base designs, ten top materials and twenty two powder coat finishes, made to order in our Michigan shop. Pick a direction below, then send us the room and we will build to it.
North Coast integrates commercial grade power and data directly into our surfaces: conference tables, workstations, credenzas and custom casework. Modular units deliver scalable power, USB-C and USB-A charging, and data and AV connectivity behind clean, concealable access that keeps cord clutter out of sight.
Every solution is UL Listed and available corded or hardwired to meet local code, with tamper resistant and hospital grade options where required.
Conference tables are built in a wide range of standard sizes, with widths spanning 36″ to 72″ and lengths from 72″ up to 288″, produced in consistent 6″ increments for layout flexibility. Standard seated height is 29.5″, with counter and bar height available on request. Tops over 96″ may be built in sections to suit freight access and on-site installation.
Small to mid-size. No center support base.
- Lengths
- 72, 78, 84, 90, 96, 102, 108, 114, 120, 126, 132 and 138 inches
- Widths
- 36, 42, 48, 54, 60, 66 and 72 inches
- Height
- 29.5″ seated standard
Large. Single center support base for added stability.
- Lengths
- 144, 150, 156, 162, 168, 174, 180, 186 and 192 inches
- Widths
- 36, 42, 48, 54, 60, 66 and 72 inches
- Height
- 29.5″ seated standard
Extra long. Dual center supports for oversized applications.
- Lengths
- 198 through 288 inches, in 6 inch increments
- Widths
- 36, 42, 48, 54, 60, 66 and 72 inches
- Height
- 29.5″ seated standard
Custom sized to the room.
- Widths
- 24″ to 120″
- Depths
- 24″ to 54″
- Height
- 27.5″ to 48″, floor to desktop
Send us the room dimensions, seating count and a finish direction. We quote custom work in a couple of days and build it in our own shop.
Every base on this page can carry any of these profiles. Pick one to see it drawn, then send us the room and we will build to it.
The default. Maximum seating for a given footprint, and the easiest shape to fit into a square room.
Tapered ends with bowed sides. Sightlines open up across the table, which is why it is the common choice for board rooms.
Straight sides with fully radiused ends. Softer to walk around than a rectangle when the room is tight.
A true ellipse, curved on every edge. Reads lighter than a racetrack at the same length.
Even sightlines and no head of the table. Common in smaller meeting rooms and private offices.
Four equal sides. Suits huddle rooms and small collaborative spaces.
Square ends with bowed sides. Adds width through the middle without making the table longer.
One square end, one radiused end. Useful where a table meets a wall or a credenza run.
The natural edge of the slab left intact along the long sides. No two tops are the same.
Six sides with angled ends. A geometric alternative to a boat shape.
Three runs joined into a U with open access in the centre. Built for training rooms and presentations.
Two runs meeting at an angle, turning the room toward a single focal point.
Drawn to your specification. Send the profile and we build to it.